User's Manual

Setting the Flash Trigger
Output Value Settings
In the M mode
1 . Press the group button to choose the group, turn the select dial, and the power
output value will change from Min to 1/1 in 0.3 stop increments. Press the <SET>
button to confirm the setting.
2. Press <ALL> button to choose all groups’ power output value, turn the select dial,
and all groups’ power output value will change from Min to 1/1 in 0.3 stop
increments. Press <ALL> button again to confirm the setting.
Note: Min. refers to the minimum value that can be set in M or Multi mode. The minimum value can be
set to 1/128 0.3, 1/256 0.3, 1/128 0.1, 1/256 0.1, 3.0(0.1) and 2.0(0.1) according to C.Fn-Min.
For most of camera flashes, the minimum output value is 1/128 and cannot be set to 1/256. However,
the value can change to 1/256 when using in combination with Godox strong power flashes e.g. AD600,
etc.
In the TTL mode
Press the group button to choose the group, turn the select dial, and the FEC value will
change from -3 to ~3 in 0.3 stop increments. Press the <SET> button to confirm the
setting.
Flash Exposure Compensation Settings
CH 01
A
B
C
ON
1/128
ON
1Hz
1Times
1. In the multi flash (TTL and M icon are not
displayed).
2. The three lines are separately displayed as power
output value, Hz(flash frequency) and Times(flash
times).
3. Press the <SET> button and turn the Select Dial to
change the power output value from Min. to 1/4 in
integer stops.
4. Press the <SET> button again and choose Hz to
change flash frequency. Turn the select dial to
change the setting value.
5. Press the <SET> button again and choose Times to
change flash times. Turn the select dial to change
the setting value.
6. Until all the amounts are set. Or during any value
setting, short press the <SET> button to exit the
setting status.
7. In the multi flash setting submenu, short press the
<MODE> button to return to main menu when no
values are blinking.
Multi Flash Settings (Output Value, Times and Frequency)
Setting the Flash Trigger
Note: As flash times are restricted by flash output value and flash frequency, the flash times cannot
surpass the upper value that permitted by the system. The times that transported to the receiver end are
a real flash time, which is also related to the camera’s shutter setting.
- 32 -- 31 -