User Manual

ManualsBrandsGodox ManualsLighting & StudioXProF TTL Wireless Flash Trigger for Fujifilm Cameras

Change the wireless channels and wireless ID to avoid interference for it can only be

triggered after the wireless IDs and channels of the master unit and the slave unit are set

to the same.

Press the <MENU> button to enter C.Fn ID. Press the <SET> button to choose OFF

channel expansion shutdown, and choose any figure from 01 to 99.

Note: This function can only be used when the master unit and slave unit both have wireless ID functions.

Wireless ID Settings

Mode Setting

Switch between multi-group and one-group mode: choose a group in multi-group mode

and press the <TCM> button to magnify it to one-group mode. Then, press the <TCM>

button to back to multi-group.

Magnification Function

Output Value Settings

1. Short press the <MODE> button, and the mode of the

current group will change.

2. Set the groups to five groups (A-E)

2.1 When displaying multiple groups, press the <MODE>

button to switch the multi-group mode to MULTI

mode. Press the group selection button can set the

MULTI mode to ON or “--” off .

2.2 When displaying multiple groups, press the group

selection button or <MODE> button in one-group

mode, and all the current group’s mode will be

changed by the order of TTL/M/--.

3. When setting the group to 16 groups (0-F), there is only

manual mode M.

4. Long press the <MODE> button for 2 seconds until

“LOCKED” is displayed on the bottom of the LCD panel,

which means the screen is locked and no parameters

can be set. Long press the <MODE> button for 2

secondsagain to unlock.

1. Multi-group displays in the M mode

1.1 Press the group button to choose the group, turn the select dial, and the power

output value will change from Min to 1/1 in 0.3 stop increments. Press the

<SET> button to confirm the setting.

1.2 Press <ALL> button to choose all groups’ power output value, turn the select

dial, and all groups’ power output value will change from Min to 1/1 in 0.3 stop

increments. Press <ALL> button again to confirm the setting.

2. One-group displays in the M mode

Turn the select dial and the group’s power output value will change from Min to 1/1

in 0.3 stop increments.

Note: Min. refers to the minimum value that can be set in M or Multi mode. The minimum value can be

set to 1/128 or 1/256 according to C.Fn-Min. For most of camera flashes, the minimum output value is

1/128 and cannot be set to 1/256. However, the value can change to 1/256 when using in combination

with Godox strong power flashes e.g. AD600, etc.

Setting the Flash Trigger Setting the Flash Trigger

CH1

1/64

Zm/CH Times Hz

MOD

3 Times

1 Hz

MULTI

CH1

1/64

CH1

1/64

LOCKED

- 34 -- 33 -