User Manual

5
Product Layout
Figure 1: Transmitter and Receiver
No. Name Description
1 Mode Switcher
- CTRL: RS-232 pass-through
- UPDATE A: Firmware update mode
- UPDATE B: Update compression IC
2 Power LED Red when power adapter is connected
3
HDMI IN (Transmitter) Connects to your HDMI source
HDMI OUT (Receiver) Connects to your HDMI display
4
3-Pin Terminal Block
(Transmitter)
RS-232 pass-through. Connects to your
computer's RS-232 port using the included
RS-232 cable
3-Pin Terminal Block
(Receiver)
RS-232 pass-through. Connects to your
end device's RS-232 port using the
included RS-232 cable
5IR IN
Plug the IR Receiver Extension cable here,
receives signals from an IR remote control
6IR OUT
Plug the IR Blaster Extension cable here,
transmitts the signals from an IR remote
control
7
HDBT OUT (Transmitter)
Connects to the HDBT IN of the Receiver
using a CAT5e/6 cable
HDBT IN (Receiver)
Connects to the HDBT OUT of the
Transmitter using a CAT5e/6 cable
8 DC 12V Power Jack
Plug the included power adapter into
either power jack, to power both units