User Manual

Figure 2: Transmitter (TX)

Link LED

• Link LED: Turns red when powered. Turns blue when

there is an HDMI signal detected

• Reset: Press to reset if HDMI Extender doesn't work

properly

• IR Out: Infrared 3.5mm socket. Plug IR Blaster extension

cable here. See instructions on page 7.

• RJ45 (1): Link to Receiver 1's RJ45 via a Cat5e/6 cable

• RJ45 (2): Link to Receiver 2's RJ45 via a Cat5e/6 cable

• HDMI In: Connect your HDMI source here with an HDMI

cable (cable not included)

• RJ45 (3): Link to Receiver 3's RJ45 via a Cat5e/6 cable

• RJ45 (4): Link to Receiver 4's RJ45 via a Cat5e/6 cable

Reset