- Hastings Entertainment Power Supply User Manual

Page
4
of
42
10.5.2. ZERO TO TEN VOLT OPERATION......................................................................................................23
10.5.3. FOUR TO TWENTY MILLIAMP OPERATION........................................................................................23
10.6. SETTING LIMIT ALARMS...........................................................................................................24
10.6.1. SETTING A SINGLE CHANNEL’S HIGH LIMIT......................................................................................24
10.6.2. SETTING A SINGLE CHANNEL’S LOW LIMIT.......................................................................................24
10.6.3. SETTING A SINGLE CHANNEL’S HYSTERESIS.....................................................................................24
10.7. SETTING RATIO CONTROL PARAMETERS ..............................................................................25
ENABLING RATIO CONTROL ........................................................................................................................25
10.8. CALIBRATING A CHANNEL TO ITS INCOMING SIGNALS ......................................................26
10.8.1. RESETTING THE ZERO ONLY............................................................................................................26
10.8.2. RESETTING THE SPAN ONLY............................................................................................................26
10.8.3. RESETTING ZERO AND SPAN............................................................................................................27
10.8.4. SETTING A MULTIPLICATION FACTOR..............................................................................................27
10.9. SERIAL COMMUNICATION........................................................................................................28
10.9.1. COMMANDS....................................................................................................................................28
10.9.2. SET POINT QUERIES ........................................................................................................................28
10.9.3. ALARM/FLAG QUERIES ....................................................................................................................28
11.0 APPENDIX A.......................................................................................................... 30
12.0 APPENDIX B.......................................................................................................... 33
13.0 APPENDIX C......................................................................................................... 33
14.0 APPENDIX D......................................................................................................... 36
15.0 DRAWINGS........................................................................................................... 41
16.0 WARRANTY.......................................................................................................... 42
16.1. WARRANTY REPAIR POLICY.............................................................................................................42
16.2. NON-WARRANTY REPAIR POLICY.....................................................................................................42