Owners Manual

TROUBLESHOOTING
FAQ
ACTION DESCRIPTION HOW TO ADJUST IT
CLEANING THE UNIT
•
Use EXTREME care and ONLY very soft cotton
cloth to clean the unit.
Any acid will irreversibly damage the unit fine
finishes.
Do not use any alcohol to clean the unit. Only
dry cloth is allowed.
SYMPTOM
DESCRIPTION
CAUSE REMEDY
SPEAKER HUMMING
PROBLEMS
• The tone arm is not correctly
Grounded.
The speakers hum
when the cable is
connected to the
Amplifier.
• The cartridge connectors are not
well inserted.
• The Ground DIN connector slots
do not touch each other.
• Verify the cartridge connectors
are well inserted.
• Be sure the DIN slot contacts touch
each other well.
• Adjust the Azimuth of the Head-Shell
with the supplied 0,9mm Allen Wrench
as described in the specific chapter of
this manual.
• The interconnect input and/or
output cables of the amplifiers are
not shielded.
• Be sure the Phono Cable DIN
Connector is well inserted in the tone
arm female DIN.
• Be sure to always use shielded
cables for the amp connections.
TONE ARM TRACKS BAD
The Headshell is bent.
The Vertical Tracking
Angle of the arm is
Wrong.
• Adjust the VTA moving the arm shaft by
loosing the three hex-bolts placed on the
edge on the arm board collar with the
help of the 1,5mm Allen Wrench supplied.
FAQ & TROUBLESHOOTING
TROUBLESHOOTING
For spare parts visit the official Gold Note store at:
http://www.akamaiaudio.it/
10