Owners Manual

22
EN
DE
IT
| TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The GN remote control
doesn’t control the DS-10.
The App can’t nd the
DS-10 in the network.
| The GN remote control
can be used to control
more than one unit. To
control each unit the
correct mode must be
selected on the remote.
| Select DAC mode on the
remote.
The button “DAC” is
located in the upper part
of the remote.
| The DS-10 is not
connected to the network.
| Make sure the DS-10 is
connected to the WLAN
or LAN either with the
Ethernet cable or the
Wi-Fi.
| Make sure the RF antenna
is correctly installed. It
may be impossible to use
the DS- 10 with the Wi-Fi
if the RF antenna is not
installed.
| When using Wi-Fi,
make sure the DS-10 is
connected to the correct
WLAN. Don’t forget to
put in the password to
complete the connection
if required by your
network setup.