Owners Manual

SETTINGS
From the SETTINGS menu you can check the
firmware version installed on the unit, reset
it and select the mode key used to control it
with the remote.
To enter the menu, first turn off the Master
Switch located on the rear panel, then press
and keep pressed the SKC (knob on the front
panel) while switching back on the Master
Switch.
FIRMWARE VERSION
The firmware version is shown at the bottom
of the display.
REMOTE CONTROL
Select the mode key assigned to the
PH-1000 by the remote. The combination
SHIFT + PRE is set by default - press SHIFT
and then PRE on the remote to control the
PH-1000. If you set the PH-1000 to PRE,
then simply press the mode key PRE on the
remote.
Once you have selected the desired mode
key, press the knob once to confirm the
selection - the unit will save and go on
standby.
FACTORY RESET
The factory reset function can be used to
reset the PH-1000 to the default settings.
Select SAVE to reset the unit or CANCEL
to exit the menu, press the knob once to
confirm the selection - the unit will save it
and go on standby.
13
|
SETTINGS, FACTORY RESET AND
| FIRMWARE VERSION