Use and Care Manual

ADJUSTING THE WEIGHT RESTS AND THE

SAFETY SPOTTERS

To adjust the height of the Weight Rests (12), raise

the Weight Rests to the desired height and tighten

an Adjustment Knob (35) into each Upright (11).

Make sure that the Weight Rests are at the same

height and that the Adjustment Knobs are fully

tightened into the Uprights.

To adjust the position of the Safety Spotters (13),

move the Safety Spotters to a different set of pegs

on the Uprights (11). Make sure that the Safety

Spotters are at the same height.

REMOVING THE CURL BAR

When performing exercises that do not require the

Curl Bar (17), pull the Curl Bar Pin (33) out of the

Leg Lever (5) and remove the Curl Bar.

When attaching the Curl Bar (17), insert the Curl Bar

Pin (33) completely through the Leg Lever (5).

Pegs