Instructions / Assembly

7
2. Identify the Left Upright Base (13), which is
marked with a “Left” sticker.
Orient a Stabilizer (5) so that the square holes
are facing the floor.
Attach the Left Upright Base (13) to the Stabilizer
(5) with two M10 x 47mm Carriage Bolts (44)
and two M10 Locknuts (40). Do not tighten the
Locknuts yet.
Then, insert two M10 x 47mm Carriage Bolts
(44) upward into the Stabilizer (5) as shown.
Repeat this step with the Right Upright Base
(20) and the other Stabilizer (5).
5
5
40
40
20
44
Square
Holes
13
2
ASSEMBLY
• To hire an authorized service technician to
assemble the weight bench in your home, call
1-800-445-2480.
• Assembly requires two persons.
• Because of its size and weight, assemble the
weight bench in the location where it will be used.
Make sure that there is enough clearance to walk
around the weight bench as you assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you complete all assembly steps.
• To identify small parts, see page 6.
• The following tools (not included) may be
required for assembly:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly will be more convenient if you have
a socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches. To avoid
damaging parts, do not use power tools.
1. Go to www.workoutwarehouse.com/
registration on your computer and register
your product.
• activates your warranty
• saves you time if you ever need to contact
Customer Care
• allows us to notify you of upgrades and offers
Note: If you do not have Internet access, call
Customer Care (see the front cover of this
manual) and register your product.
1
44