Operating Instructions 7K BTU 2.
General Care and Safety Guide Thank you for choosing this Goldair product. This Goldair appliance has been designed and manufactured to high standards of engineering and with proper use and care, as described in this leaflet, will give you years of useful service. Please read these instructions carefully and keep them for future reference. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27.
General Care and Safety Guide 28. Never twist, kink or wrap the cord around the appliance, as this may cause the insulation to weaken and split. Always ensure that all cord has been removed from any cord storage area and is unrolled before use. 29. Never use this appliance in the immediate surrounds of a bath, a shower, or a swimming pool or other liquids. The appliance must not be immersed in any liquids. 30. Due to the risk of injury, never use this appliance for any purpose other than its intended use.
Components
Installation NOTE: The air-conditioner should be installed on a flat surface with at least 300mm clearance all around, including from the top of the unit as it is important that the air outlet is not blocked. Power supply must be nearby. WARNING: THIS APPLIANCE MUST BE INSTALLED, OPERATED AND STORED IN A ROOM WITH A FLOOR AREA LARGER THAN 7m2 Do not install and use the appliance in the bathroom or other humid environments. Install the heat pipe assembly (as shown in Figure 1).
Control Panel and Remote Control This Portable Air Conditioner is designed to be operated in cooling mode, fan mode or dehumidifying mode. When switching between these functions keep an interval of at least 3 minutes between each ON/OFF. Allow the refrigerant to settle by leaving the appliance to stand for two hours after transport or after the unit has been on its side. Ensure the unit is in the OFF setting before connecting it to the mains supply.
Control Panel and Remote Control 6. Fan Speed Button In cooling or fan mode press the button to select between high or low fan speed operation. In dehumidification mode the fan will automatically be set to low speed operation. This cannot be changed. 7. Timer Setting Button The timer can be set to turn the unit ON or OFF from 1-24 hours. To set the timer to turn the unit OFF, press the TIMER button while the unit is operating and set the desired number of hours before the unit turns off.
Care and Maintenance Manual Drainage The unit will stop once it has filled with water. Turn off the unit and unplug the power plug. Move the unit carefully, so as not to spill the water in the water pan at the bottom of the body. Find a place to drain the water or place a bucket below the water outlet on the back of the unit. Unscrew the drainage cover and unplug the water plug, the water will automatically flow into the water container. During drainage, the body can be tilted slightly backwards.
Care and Maintenance CARE AND CLEANING Clean the upper filter screen frame • Unscrew screw fixing the EVA filter screen and the rear housing to remove the EVA filter screen (as shown in the below figure) • Put the EVA filter screen into warm water with neutral detergent (about 40 ℃ / 104 ℉) and dry it in the shade after rinsing clean. NEVER USE UNIT WITHOUT THE AIR FILTER. The exterior may be cleaned with a soft, dry cloth.
Troubleshooting Problems Reasons Solutions Turn it on after connecting it to a There is no electricity. socket with electricity. The water-full indicator will flash. Discharge the water inside. Recommend to use the machine The ambient temperature is too in at the temperature of 7-35 ℃ low or too high (44-95 ℉). The air conditioner does In cooling mode, the room temperature is lower than the not work. set temperature; in heating Change the set temperature.
One Year Warranty Thank you for purchasing this Goldair product. Your product is warranted against faults and manufacture when used in normal domestic use for a period of one year. In non-domestic use Goldair limits the voluntary warranty to three months. Goldair undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault during the warranty period.
New Zealand PO Box 100707, North Shore Mail Centre, Auckland, 0745 www.goldair.co.nz Australia PO Box 574, South Morang, Victoria, 3752 www.goldair.com.
