Owner's manual

Canopy

1ea

Mounting Screws 2ea Top loop 1ea

Chain 6ft Wire Connectors 3ea Spring Washer 1ea

Chain connector

2ea

Canopy Loop

with Collar

1ea Nipple 1ea

Mounting Strap 1ea Hex Nut 3ea

Green Ground

Screw

1ea

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

PARTS & ASSEMBLY SHEET

This fixture assembled PO:__________ Date: ________

Fixture Name: Cerchi 1030-9 CH

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are

missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement

parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

FIXTURE ASSEMBLY INSTRUCTIONS

For Customer Service, contact the place of purchase to arrange for replacement parts.

NOTE: INSTALL THE GLASS ASSEMBLY AFTER

THE FIXTURE IS HUNG.

ASSEMBLING THE FIXTURE (Fig.1)

1. Grasp the fixture wires and align the Center column

Nipple (M) to Fixture coupler (I) and thread Center

column(M) to Fixture coupler (I) until tight. Ensure the

fixture wires are not pinched in the coupler.

2. Gently spread the arms until evenly spaced if arms

are packed closed.

3. The Center column rings may be turned to your

desired angle.

1030-9 CH

Read and review installation instruction sheet before

assembling the fixture.

Fig 1

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Cerchi 1030-9 CH This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts. Company Name:_______________________Co.
PAGE 2
PARTS & ASSEMBLY SHEET Fixture Name: ASSEMBLING THE FIXTURE (Fig.2) Cerchi 1030-9 CH Fig 2 4. Feed the fixture wires through the Top loop (D2) and pull the wires until taut. Then screw the Top Loop（D2） to the coupling on the top of fixture (D) until tight. 5. By measuring determine correct number of links needed for proper hanging height. Use a pair of pliers to open one link of the Chain (C2) then remove the excess Chain (C2) and discard it. 6.
PAGE 3
INSTALLATION INSTRUCTIONS Fixture Name: Cerchi 1030-6, 9, 363, 3P, D5, M1L CH For Chandelier Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) Fig. 1 1. Carefully remove the new fixture from the carton and the yellow bag that holds all parts. Check that all parts are included as shown in the illustration and parts list. 2. Shut off the power at the circuit breaker and remove old fixture from ceiling, including the old mounting strap. 3.