User guide

Anchor 2ea

Junction box

screw

2ea

Mounting

plate

Anchor screw 2ea

Wire

connnector

2ea

1 ea

Green ground

screw

1ea

Deco nut

(round nut)

2ea

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts

are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for

replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

PARTS & ASSEMBLY SHEET

This fixture assembled PO:__________ Date: ________

Fixture Name: Cerchi 1030-BA3 CH

FIXTURE ASSEMBLY INSTRUCTIONS

For Customer Service, contact the place of purchase to arrange for replacement parts.

NOTE: INSTALL THE GLASS ASSEMBLY

AFTER THE FIXTURE IS HUNG.

SSEMBLING THE FIXTURE (Fig.1)

1.Slide the Glass Shade ( H ) over Socket (G) and

secure secure with Socket washer ( I ) and by

threading the Socket Ring (K) to Socket (G) until

tight.

2. Install the light bulb in accordance with the

fixture's specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING!)

Fig 1

1030-BA3 CH

Read and review installation instruction sheet

before assembling the fixture.

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Cerchi 1030-BA3 CH This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
INSTALLATION INSTRUCTIONS Fixture Name: Cerchi 1030-BA3 CH For Wall Mount Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) Fig. 1 1. Carefully remove the new fixture from the carton and the yellow bag that holes all your parts. Check that all parts are B included as shown in the illustration and parts list. 2. Shut off power at the circuit breaker and remove the old fixture from wall, including the old mounting strap. 3.