Manual

ManualsBrandsGolden Lighting ManualsLighting1030-M1L CH

Canopy

1ea

Mounting

screws

2ea Top loop 1ea

Chain 1ft

Wire

connectors

3ea Nipple 1ea

Chain connector

2ea

Canopy loop

with Collar

1ea Mounting strap 1ea

Socket rings 1ea Hex nut 3ea

Green ground

screw

1ea

12" Rod

2ea

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

PARTS & ASSEMBLY SHEET

Fixture Name: Cerchi 1030-MIL CH

This fixture assembled PO:__________ Date: ________

Notice:

Please review the parts listing and check for all parts before assembling the fixture. If any parts

are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for

replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

FIXTURE ASSEMBLY INSTRUCTIONS

Read and review installation instruction sheet

before assembling the fixture.

1030-MIL CH

ASSEMBLING THE FIXTURE (Fig.1)

1. By measuring determine correct number of rods

and chain needed for proper hanging height.

There is 1 foot of chain and 2 optional 12" rods

included.

2. To shorten the fixture slide the excess 12" rods

off the wire.

3. To lengthen the fixture thread the additional

rods onto the wire or substitute longer chain for

the 1 foot length included.

Fig 1

NOTE: INSTALL THE GLASS ASSEMBLY

AFTER THE FIXTURE IS HUNG.

For Customer Service, contact the place of purchase to arrange for replacement parts.

These two Rods may

be removed

additional Rods may

be added.

ROD-12 CH *

additional chain may

be added.

CHAIN-CH *

*available for purchase

separately

Summary of content (3 pages)

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Cerchi 1030-MIL CH This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
PARTS & ASSEMBLY SHEET Fixture Name: Cerchi 1030-MIL CH Fig 2 ASSEMBLING THE FIXTURE (Fig.2) 4. Pull the fixture’s wire through the Rods until taut. 5. Thread Rod ( I ) into Frame (Q) until tight. 6. Thread Rod (M)into Rod ( I ) until tight. repeat for any additional rods. 7. Feed the fixture wires through the Top loop (D2 , J) and pull the wires until taut. Then screw the Top Loop（D2） to the rod on the top of fixture (M) until tight. 8.
PAGE 3
INSTALLATION INSTRUCTIONS Fixture Name: Cerchi 1030-6, 9, 363, 3P, D5, M1L CH For Chandelier Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) Fig. 1 1. Carefully remove the new fixture from the carton and the yellow bag that holds all parts. Check that all parts are included as shown in the illustration and parts list. 2. Shut off the power at the circuit breaker and remove old fixture from ceiling, including the old mounting strap. 3.