Instructions / Assembly
Assembly Instructions: 1405-1W (Travers)
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important notes above. Shut off the power at the circuit breaker and completely
remove the old xture from the wall, including the old mounting strap.
Mounting strap (B) contains several pairs of threaded holes. Find the pair of holes that matches the spacing of the holes on the junction
box and the backplate. Two of mounting screws (A) should be attached to mounting strap (B). You may need to tighten the nuts that hold
these screws in place. Pull the house wires through the center of mounting strap (B). Place mounting strap (B) over the junction box so
that mounting screws (A) are horizontal, and in alignment with the locations of the holes on backplate (G). Secure mounting strap (B) to the
junction box with mounting screws (D) and a screwdriver. Tighten the screws securely.
CONNECTING THE WIRES
Attach the xture’s wires to the power supply wires from the junction box. Connect black (hot) to smooth/black/transparent (L); white
(neutral) to ribbed/white/transparent (N); ground (green) to bare copper/green/transparent with green interior. Twist the ends of the wire
pairs together, and then twist on a wire connector. Make sure all twists are in the same direction. If there is no ground wire (green or
copper) from the junction box, locate ground screw (E) on the mounting bracket/mounting strap and wrap the xture’s ground wire around
the green ground screw (E). Use a screwdriver to secure ground screw (E) onto the mounting bracket/mounting strap. Tuck all wires neatly
into the junction box.
FINISHING THE INSTALLATION
Place backplate (F) over mounting screws (A) so that mounting screws (A) protrude through the holes in the front of the backplate. Thread
deco nuts (G) onto mounting screws (A). Twist until backplate (F) is snug against the wall.
Note: Complete the remaining steps after the xture has been hung.
Carefully slide spider (K) over socket (H) before sliding glass shade (I) over socket (H). Secure the glass in place with socket cover (L).
Repeat until all glass shades are hung. Install light bulb (J) in accordance with the xture’s specications. Do not exceed the maximum
recommended wattage.
Your installation is now complete. Turn on the power and test the xture.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
Smooth / Black /
Transparent (L)
Black (Hot)
Ribbed / White /
Transparent (N)
Bare Copper / Transparent with
Green Interior / Green
White (Neutral)
Green
(Ground)
For Customer Service, contact the
place of purchase.
G
C
A
B
E
D
F
I
J
H
K
L