Installation Guide

For Customer Service, contact the place of purchase to arrange for replacement parts.
2073-3P GMT PARTS AND ASSEMBLY SHEET
PARTS & ASSEMBLY SHEET
This fixture assembled PO: Date:
Fixture Name: SMYTH 2073-3P GMT
Notice: Please review the Parts List and check for all parts before assembling the fixture. If any
parts
are missing or damaged, please note on this sheet and contact the place of purchase
to arrange for replacement parts.
PARTS LIST
Company Name:_____________ Co Account#:__________
below to be filled out by retailer
Mounting Strap
3/4"*1" 1ea
Green Screw
G8/32*H8
1ea
Mounting Screws
H32
2ea
Wire Connectors
Orange 3ea
Hex Nut
G
3/8*H4 2ea
Top Loop
57*65 1ea
Tube
Φ22*50mm 3ea
Nipple
3/8
*H45MM 1ea
Canopy 1ea
126*126*H25MM
Chain
1ea 6FT*Φ4.2mm
Threaded
Ring
1ea
Φ23
-16T*H5mm
Screw Collar Loop
1ea 3/8"*H42.4mm
Chain Connector
2 ea Φ4*H55mm
Part Needed ______________________________ Quantity _________________________________
Part Needed ______________________________ Quantity _________________________________
Reason why (missing, scratched, broken glass, bent, bad finish)
Comments __________________________________________________________________________
FIXTURE ASSEMBLY INSTRUCTIONS
Read and review installation instruction sheet
before assembling the fixture
1. Feed the fixture wires through Rod (V) to
Center Rod (K) and connect the rods
well.
2. Hook the top of Center Rod (K) to the Top
Loop (J).
3. Connect the Top Loop (J) to the chain.
4. Hook Hanger Rods (R) to the Frame (S),
then hook the top of Hanger Rods (R) to
the Top Loop (J).
5. Slide the Candle Sleeves (U) over the
sockets.
2073-3P GMT
Fig.1
G
CHAIN
J
H
F
K
R
S
T
U
V

Summary of content (2 pages)