Installation Guide
Assembly Instructions: 2220-M1L (Nicolette)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important notes above. Shut o
the power at the circuit breaker and completely remove the old xture from the ceiling,
including the old mounting strap.
From the parts bag remove the mounting strap assembly. One end of nipple (F) should
be attached to mounting strap (A) with washer (C) and hex nut (D) in place. The other end
should have canopy loop (H) attached. Attach mounting strap (A) to the junction box using
mounting screws (B) and a screwdriver. Tighten securely. Unscrew canopy loop collar (I)
from canopy loop (H). Pass canopy (G) over the mounted canopy loop to test the height.
Approximately half of the canopy loop’s exterior threads should be exposed, and the canopy
loop collar should t snugly onto the canopy loop. Remove canopy (G) and adjust the height
of nipple (F) and canopy loop (H) until the desired height is reached.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn o the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
For Customer Service, contact
the place of purchase.
FINISHING THE INSTALLATION
Push canopy (G) up to the ceiling. Slide canopy loop (H) and canopy loop collar (I) up beneath the canopy. Tightly thread canopy loop collar (I) onto
canopy loop (H) to secure canopy (G) in place.
Install a light bulb (not provided) in accordance with the xture’s specications. Do not exceed the maximum recommended wattage.
Your installation is complete. Turn on the power and test the xture.
ASSEMBLING THE FIXTURE
By measuring, determine the correct number of chain links needed for proper hanging
height. If necessary, use a pair of pliers to open and remove any excess chain. Attach chain
connectors (K) to each end of chain (J) before attaching one end of the chain connector/
chain to top loop (L). Close the chain connector. Connect the other chain connector (K) to
canopy loop (H). Feed the xture’s wires up through top loop (L) then through chain (J) (every
three links or so). Pull the wires until taut. Gently slide canopy loop collar (I) and canopy (G)
onto the chain/wires.
CONNECTING THE WIRES
Have an assistant support the xture’s weight while completing the wiring. Cut away excess
wire. Attach the xture’s wires to the power supply wires from the junction box. Connect
black to smooth/black/transparent (L) wire; white to ribbed/white/transparent (N) wire;
ground to ground (green or copper). Twist the ends of the wire pairs together, and then twist
on a wire connector. Make sure all twists are in the same direction. If there is no ground wire
(green or copper) from the junction box, locate ground screw (E) on mounting strap (A) and
wrap the xture ground wire around the green ground screw (E). Use a screwdriver to secure
ground screw (E) onto the mounting bracket/mounting strap. Tuck all wires.
A
C
D
E
F
G
H
I
J
B
L
K
M
N
O