Installation Sheet
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
CONNECTING THE WIRES
Have an assistant support the xture’s weight while completing the wiring. Attach the
xture’s wires to the power supply wires from the junction box. Connect black to smooth/
black/transparent (L) wire; white to ribbed/white/transparent (N) wire; ground to ground
(green or copper). Twist the ends of the wire pairs together, and then twist on a wire
connector. Make sure all twists are in the same direction. If there is no ground wire (green
or copper) from the junction box, locate ground screw on mounting strap (B) and wrap
the xture ground wire around the green ground screw. Use a screwdriver to secure
ground screw onto the mounting bracket/mounting strap. Tuck all wires neatly into the
junction box.
For Customer Service, contact
the place of purchase.
Assembly Instructions: 3306-L, M, S (Orwell)
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn o the light and wipe down
the xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture. Hand wash the glass with warm
waterand mild detergent. Dry with a lint-free or microber cloth.
PREPARING FOR INSTALLATION
Carefully remove all of the contents from the carton. See the important notes above. Shut
o the power at the circuit breaker and completely remove the old xture from the ceiling,
including the old mounting strap.
From the parts bag remove the mounting strap assembly. Mounting strap (B) contains
threaded holes. Two of mounting screws (A) should be attached to mounting strap (B). You
may need to tighten nuts (C) that hold these screws in place. Place mounting strap (B) over
the junction box so that mounting screws (A) are vertical, and in alignment with the hole
locations on the xture’s canopy (F). Secure mounting strap (B) to the junction box with
mounting screws (D) and a screwdriver. Tighten the screws securely.
ASSEMBLING THE FIXTURE
For adjusting the height of xture, this xture has an adjustable woven cord. By measuring,
decide the desired overall height of your xture and determine how much of the cord is
needed to achieve the desired height. Add at least 8 to 10 inches to your desired length
before trimming the cord.
FINISHING THE INSTALLATION
Push canopy (F) up to the ceiling and tightly thread decorative nuts (H) onto the exposed threads of mounting screws (A).
Secure spider (N) to shades (N) with screws (M) and decorative cap (L). Carefully slide shades (N) over sockets (J) and secure the shades in place
with socket rings (O).
Twist light bulbs (P - not provided) into sockets (M) in accordance with the xture’s specications. Do not exceed the maximum wattage.
Your installation is now complete. Turn on the power and test the xture.
B
JUNCTION
BOX
D
A
E
C
F
H
I
J
K
L
M
O
P
N
G