Installation Guide

Assembly Instructions: 3602-1W (Duncan)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completelyremovetheoldxturefromthewall,includingthe
oldmountingstrap.
Mountingstrap(B)containsseveralpairsofthreadedholes.
Findthepairofholesthatmatchesthespacingoftheholeson
thejunctionboxandyourxturebackplate.Twoofmounting
screws(A)shouldbeattachedtomountingstrap(B).You
mayneedtotightenthenutsthatholdthesescrewsinplace.
Pullthehousewiresthroughthecenterofmountingstrap
(B).Placemountingstrap(B)overthejunctionboxsothat
mountingscrews(A)arehorizontal,andinalignmentwiththe
holelocationsonthexturebackplate(G).Securemounting
strap(B)tothejunctionboxwithmountingscrews(D)anda
screwdriver.Tightenthescrewssecurely.
CONNECTING THE WIRES
Attachthexture’swirestothepowersupplywiresfromthe
junctionbox.Connectblacktoblack(orsmooth);whiteto
white(orribbed);groundtoground(greenorcopper).Twist
theendsofthewirepairstogether,thentwistonawire
connector. Make sure all twists are in the same direction. If
thereisnogroundwire(greenorcopper)fromthejunction
box,locategroundscrew(E)onmountingstrap(B)andwrap
thexturegroundwirearoundthegreengroundscrew(E).Use
ascrewdrivertosecuregroundscrew(E)ontothemounting
bracket.Tuckallwiresneatlyintothejunctionbox.
FINISHING THE INSTALLATION
Placexturebackplate(F)overmountingscrews(A)sothat
theyprotrudethroughtheholesinthefrontofthebackplate.
Threaddeconuts(G)ontomountingscrews(A).Twistuntil
backplate(F)ofthextureissnugagainstthewall.
Slide shade (I) onto socket (H) and secure with socket washer
(J)andsocketring(K).
Installthelightbulb(L)(notprovided)inaccordancewith
thexture’sspecications.Donotexceedthemaximum
recommendedwattage.
Your installation is now complete. Turn on the power and test
thexture.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture. For deep cleaning, turn off the light
and remove the glass prior to cleaning. Hand wash glass with warm water and mild detergent. Dry with a lint-free or microber cloth.
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)
C
B
E
D
A
F
G
L
H
I
J
K