Installation Guide

Assembly Instructions: 3602-BA1 (Duncan)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the
important notes above. Shut off the power at the circuit
breakerandcompletelyremovetheoldxturefromthewall,
including the old mounting strap.
Mounting strap (B) contains several pairs of threaded holes.
Find the pair of holes that matches the spacing of the
holesonthejunctionboxandyourxturebackplate.Two
of mounting screws (A) should be attached to mounting
strap (B). You may need to tighten nuts (C) which hold these
screws in place. Pull the house wires through the center
of mounting strap (B). Place mounting strap (B) over the
junctionboxsothatmountingscrews(A)arehorizontal,and
inalignmentwiththeholelocationsonxturebackplate(G).
Securemountingstrap(B)tothejunctionboxwithmounting
screws (D) and a screwdriver. Tighten the screws securely.
CONNECTING THE WIRES
Attachthexture’swirestothepowersupplywiresfromthe
junctionbox.Connectblacktoblack(orsmooth);whiteto
white(orribbed);groundtoground(greenorcopper).Twist
theendsofthewirepairstogether,thentwistonawire
connector. Make sure all twists are in the same direction. If
there is no ground wire (green or copper) from the junction
box,locategroundscrew(E)onmountingstrap(B)andwrap
thexture’sgroundwirearoundthegreengroundscrew
(E). Use a screwdriver to secure ground screw (E) onto the
mountingbracket.Tuckallwiresneatlyintothejunctionbox.
FINISHING THE INSTALLATION
Place backplate (G) over mounting screws (A) so that
the screws protrude through the holes in the front of the
backplate. Thread deco nuts (F) onto mounting screws (A).
Twistuntilthebackplateofthextureissnugagainstthe
wall.
Slide shade (I) over socket (H) and twist socket ring (J) onto
the threads of the socket to secure in place.
Installlightbulbsinaccordancewiththexture’s
specications.Donotexceedthemaximumrecommended
wattage.
Your installation is now complete. Turn on the power and test
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
F
D
C
A
E
B
G
I
J
H
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.