Installation Guide

Assembly Instructions: 3602-BA3 (Duncan)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completelyremovetheoldxturefromthewall,includingtheold
mountingstrap.
Mountingbracket(B)maybeattachedtobackplate(G).Ifso,
use a screwdriver to remove screws (F). Place the screws aside
forfutureuse.Mountingbracket(B)containsseveralpairsof
threadedholes.Findthepairofholesthatmatchesthespacing
oftheholesonthejunctionboxandbackplate(G).Pullthe
housewiresthroughthecenterofmountingbracket(B).Place
mountingbracket(B)overthejunctionboxandsecuremounting
bracket(B)tothejunctionboxwithmountingscrews(D)anda
screwdriver.Besurethatthemountingbracketislevel.Tighten
the screws securely.
CONNECTING THE WIRES
Attachthexture’swirestothepowersupplywiresfromthe
junctionbox.Connectblacktoblack(orsmooth);whitetowhite
(orribbed);groundtoground(greenorcopper).Twisttheends
ofthewirepairstogether,thentwistonawireconnector.Make
surealltwistsareinthesamedirection.Ifthereisnogroundwire
(greenorcopper)fromthejunctionbox,locategroundscrew
(E)onmountingbracket(B)andwrapthexture’sgroundwire
aroundthegreengroundscrew(E).Useascrewdrivertosecure
groundscrew(E)ontothemountingbracket.Tuckallwires
neatlyintothejunctionbox.
FINISHING THE INSTALLATION
Placebackplate(G)overmountingbracket(B)sothattheholes
onthetopofbackplate(G)matchupwiththeholesinmounting
bracket (B). Thread screws (F) into the holes in the top of
backplate(G)andintotheholesinmountingbracket(B).Tighten
thescrewsuntilthebackplateofthextureissnugagainstthe
wall.
Slideshade(I)oversocket(H)andtwistsocketring(J)ontothe
threads of the socket to secure in place.
Installlightbulbsinaccordancewiththexture’sspecications.
Donotexceedthemaximumrecommendedwattage.
Your installation is now complete. Turn on the power and test the
xture.
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
GE
D
B
F
Junction Box
C
H
I
J