Installation Sheet

Assembly Instructions: 3602-2SF/VL2, 3SF/VL3 (Duncan)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Carefully remove all of the contents from the carton. See
the important notes above. Shut off the power at the circuit
breaker and completely remove the old xture including the
old mounting strap.
1. From the parts bag remove the mounting strap assembly.
Mounting strap (B) contains threaded holes. Two of mounting
screws (A) should be attached to mounting strap (B). You may
need to tighten nuts (C) that hold these screws in place.
2. Pull the house wires through the center of mounting strap (B).
Place mounting strap (B) over the junction box so that mounting
screws (A) are vertical, and in alignment with the hole locations on
thexture’scanopy(G).Securemountingstrap(B)tothejunction
box with mounting screws (D) and a screwdriver. Tighten the
screws securely.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
For Customer Service, please
contact the place of purchase.
FINISHING THE INSTALLATION
4. Place canopy (G) over mounting screws (A) so that the screws protrude through the holes in the canopy.
5. Thread deco nuts (F) onto mounting screws (A).
6.Twistthescrewsuntilthecanopyofthextureisattachedsnuglytotheceiling.
7. Slide shade (I) over socket (H) and thread socket ring (K) onto socket (H) to secure the shade in place.
Installlightbulbs(notprovided)inaccordancewiththexture’sspecications.Donotexceedthemaximumwattage.
Yourinstallationisnowcomplete.Turnonthepowerandtestthexture.
*Please Note: The swivel above the shades allows the shades to be rotated 360 degrees and used as spotlights.
B
JUNCTION
BOX
H
I
K
C
D
A
E
G
F
J
CONNECTING THE WIRES
3.Haveanassistantsupportthexture’sweightwhilecompleting
thewiring.Refertothewiringdiagramandattachthexture’swires
to the power supply wires from the junction box. Connect Hot to Hot
(transparent wire with black inner thread, black, or smooth wire) Neutral
to Neutral (transparent wire with white inner thread, white, or ribbed
wire), and Ground to Ground (transparent wire with green inner thread,
green wire, or copper). Twist the ends of the wire pairs together, and then
twist on a wire connector. Make sure all twists are in the same direction.
If there is no house ground wire coming from the junction box, locate
ground screw (E) on the mounting bracket/mounting strap and wrap
thexture’sgroundwirearoundthegroundscrew.Useascrewdriverto
tighten the top of ground screw (E) onto the wires and into the mounting
bracket/mounting strap. Tuck the wires into the junction box.
*This xture may be
mounted on a wall or ceiling.
How to Identify the Fixture’s Wires
Hot Neutral Ground
Smooth
Ribbed
Bare Metal,
Green, or
Green Inner
Thread
Black
White
Black Inner
Thread
White Inner
Thread
House Wires
Fixture Wires
Hot