Installation Guide

ManualsBrandsGolden Lighting ManualsPendant LightingMulti-family Rubbed Bronze Multi-Light Transitional Cage Pendant Light

Canopy

Hex nut Nipple

1ea 130*H22mm 1ea 1/2"*H3mm 2ea 1/2"*H55mm

Chain Wire Connnector

Bottom cap

1ea 3.8mm*L72" 2ea A3 Orange

1ea 50*H56mm

Chain connector Mounting Screw Finial

2ea 5*H58.5mm 2ea 8/32"*H1" 1ea 22*H40mm

Mounting Strap

w/ ground screw

Canopy Loop

and Canopy

loop collar

1ea 100*22*H4mm

/1ea 8/32"*H10mm

1ea 1/2"*H46mm

Crystal draping

A7 x 5pcs

Crystal drops

B2 x 15pcs

Crystal drops

B5 x 5pcs

Crystal drops

C3 x 5pcs

Crystal drops

D4 x 1pcs

Part Needed Quantity

Part Needed

Quantity

Reason why

( missing, scratched, broken glass, bent, bad finish)

Comments

FIXTURE ASSEMBLY INSTRUCTIONS

NOTE: THE SHADE ASSEMBLY CAN BE DAMAGED BY

ROUGH HANDLING. USE CARE WHEN ASSEMBLING.

For Customer Service, contact the place of purchase to arrange for replacement parts.

1. Feed the fixture wires through the long Threaded rod (F)

and pull the wires until taut.

2. Slide the tube (E), tube lid (D), cup (C), long Threaded rod

(F), Top cap (B), Top loop (A) down to housing of fixture.

3. Screw Threaded rod (F) all the way into the coupler (L) at

housing of fixture. Screw Top loop (A) into Top cap (B).

8981-5 BRI / GRM

Read and review installation instruction sheet before

assembling the fixture.

Fig 1

PARTS & ASSEMBLY SHEET

This fixture assembled PO:__________ Date: ________

Fixture Name: Echelon 8981-5 BRI / GRM

Crystal drops are included in

parts bag. (see crystal assembly

instruction)

Notice:

Please review the parts listing and check for all parts before assembling the fixture. If any parts are

missing or damaged, please note on this sheet and contact the place of purchase to arrange for

replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

Fig 1

Summary of content (5 pages)

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: Echelon 8981-5 BRI / GRM This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
PARTS & ASSEMBLY SHEET Fixture Name: * NOTE: The Finial can be scratched or broken if the full Echelon 8981-5 BRI / GRM Fig 2 weight of the fixture is placed on it. To avoid damage attach the Bottom Assembly parts after hanging the fixture. 4. Slide the center support of the Fabric shade(I) over center tube to the housing, it is open on one side for ease of assembly. Secure in place by tightening Cap nut (J) to Frame (K) with frame of shade between them (I). 5.
PAGE 3
INSTALLATION INSTRUCTIONS Fixture Name: Echelon 8981-3P, 5, 9, M1L BRI / GRM For Chandelier Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) 1. Carefully remove the new fixture from the carton and the yellow bag that holds all parts. Check that all parts are included as shown in the illustration and parts list. 2. Shut off the power at the circuit breaker and remove old fixture from ceiling, including the old mounting strap. 3.
PAGE 4
PAGE 5