Installation Guide

IMPORTANT:
• ALLINSTALLATIONWORKSHOULDBEDONEBYACCREDITEDPROFESSIONAL.
• SHUTOFFPOWERSUPPLYATFUSEORCIRCUITBREAKER!
• USEONLYTHESPECIFIEDBULBS.DONOTEXCEEDTHEMAXIMUMWATTAGE!
CONNECTING THE WIRES
4.Haveanassistantsupportthexture’sweightwhilecompletingthewiring.Refertothewiringdiagramandattachthexture’s
wirestothepowersupplywiresfromthejunctionbox.ConnectHottoHot,NeutraltoNeutral,andGroundtoGround.Twisttheends
ofthewirepairstogether,andthentwistonawireconnector.Makesurealltwistsareinthesamedirection.
5.Ifthereisnohousegroundwirecomingfromthejunctionbox,locategroundscrew(E)onthemountingbracket/mountingstrap
andwrapthexture’sgroundwirearoundthegroundscrew.Useascrewdrivertotightenthetopofgroundscrew(E)ontothewires
andintothemountingbracket/mountingstrap.Tuckthewiresintothejunctionbox.
FINISHING THE INSTALLATION
6.Placethexture’scanopy(F)overmountingscrews(A)sothattheyprotrudethroughtheholesincanopy(F).
7.Threaddeconuts(G)ontomountingscrews(A).
8.Installlightbulbs(notincluded)inaccordancewiththexture’sspecications.Donotexceedthemaximumrecommended
wattage.
Yourinstallationisnowcomplete.Turnonthepowerandtestthexture.
For Customer Service, please
contact the place of purchase.
AssemblyInstructions:7856-SF (Ferris)
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
How to Identify the Fixture’s Wires
Hot Neutral Ground
Smooth
Ribbed
Bare Metal,
Green, or
Green Inner
Thread
Black
White
Black Inner
Thread
White Inner
Thread
House Wires
Fixture Wires
Hot
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See
the important notes above. Remove the old xture
from the ceiling, including the old mounting strap.
1.Takethemountingstrapassemblyfromtheparts
bag.Mountingstrap(B)containsthreadedholes.
Twoofmountingscrews(A)shouldbeattachedto
mountingstrap(B).Youmayneedtotightennuts(C)
thatholdthesescrewsinplace.
2.Pullthehousewiresthroughthecenterof
mountingstrap(B).Placemountingstrap(B)over
thejunctionboxsothatmountingscrews(A)are
horizontal,andinalignmentwiththeholelocations
onthexture’scanopy(F).
3.Securemountingstrap(B)tothejunctionbox
withmountingscrews(D)andascrewdriver.Tighten
thescrewssecurely.
A
GND
B
C
D
E
F
G