Instructions / Assembly

ManualsBrandsGolden Lighting ManualsLightingLaurel Designs Geneva 1-Light Chrome Bath Light

Table Of Contents

Mounting

Strap

4"*3"*1.5MM

1ea

Junction Box

Screw

5/32"*H28MM

2ea

Mounting

Screw

2ea

Wire

Connnector

3ea

Hex Nut

5/32"*H3.5MM

2ea

Deco Nut

(round nut)

5/32"*10.8MM

2ea

Green Ground

Screw

8/32"* H25MM

1ea

Part Needed Quantity

Reason why

( missing, scratched, broken glass, bent, bad finish)

Comments

FIXTURE ASSEMBLY INSTRUCTIONS

PARTS & ASSEMBLY SHEET

Fixture Name: AJCJ-BA1

This fixture assembled PO:__________ Date: ________

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any

parts are missing or damaged, please note on this sheet and contact Customer Service using the

information below.

PARTS LIST

For Customer Service, contact Toll Free: 800.277.0979 Ext. 0 or Email: service@laureldesigns.biz

AJCJ-BA1

Read and review installation instruction sheet

before assembling the fixture.

1. Place fixture Back Plate (K), over the

Mounting Screws (B), so that the screws protrude

through the holes in Back Plate (K).

2. Thread Deco Nuts (L) onto Mounting Screws (B)

and continue turning until Back Plate (K) is snug

against the wall.

3. Slide Glass Shade (H) and Spacer (M) over

Socket (I) and secure the glass shade by threading

the Socket Ring (J) to Socket (I).

4. Install the light bulb in accordance with the

fixture's specifications.

(DO NOT EXCEED THE MAXIMUM WATTAGE

RATING!)

Fig. 4

Summary of content (2 pages)

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: AJCJ-BA1 This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact Customer Service using the information below. PARTS LIST Mounting Strap 4"*3"*1.5MM Wire Connnector P3 1ea Junction Box Screw 5/32"*H28MM 2ea Mounting Screw 2ea 3ea Hex Nut 5/32"*H3.5MM 2ea Deco Nut (round nut) 5/32"*10.
PAGE 2
H F IX TU RE W O US E W IRE S IRE S B A C F i g . 2 D INSTALLATION INSTRUCTIONS Fixture Name: AJCJ-BA1 For Wall Mount Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) 1.Carefully remove the new fixture from the carton and the yellow bag that holds all your parts. Check that all parts are included as shown in the illustration and parts list. 2.