Users Manual

PD700-Please refer to hardware block diagram:
(1) PD700 is a plug-in Dimmer module with an 120V AC Power. The user can turn ON/OFF and
control the brightness level of the connected lighting. This can be done by the push button
on the unit or using a remote controller through RF .
(2) Connect the unit to AC 120V, 60Hz Line to get the AC power. .
(3) This module is one component of a Z-Wave control system. RF frequent Z-Wave sub-1 GHz
frequency. It’s designed to work with all other Z-Wave enabled devices in a home network.
Operation Principle of the Transceiver
The product employs ZGM130S Z-Wave 700 SIP Module as the MCU and for controlling the
wireless signal.
Introduction
The ZGM130S product family combines an energy-friendly MCU (32-bit ARM® Cortex®-M4 core at
39 MHz) with a highly integrated radio transceiver. The devices are well suited for any battery
operated application, as well as other system where ultra-small size, reliable high performance RF,
low-power consumption and easy application development are key requirements. This section
gives a short introduction to the full radio and MCU system.
Radio
The ZGM130S features a radio transceiver supporting Z-Wave protocol. The RF transceiver can handle 40kbit/s
and 100kbit/s data simultaneously. Channel 0 is 916MHz, 100Kbit/s, channel 1 is 908.4Hz, 40kbit/s.
Antenna Interface
The antenna interface consists of a single pin, connected to internal balun and matching network.
FCC statements:
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications or changes to this equipment. Such modifications or changes could
void the user’s authority to operate the equipment.