Owner’s Manual Stainless Steel Range Hood Island Mounts: Type C Only Copyright ShopRangeHoods.com© 2016 Office: +1 (626) 321-9834 Email: support@shoprangehoods.com Distributed by ShopRangeHoods.
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally.
TOOLS & PARTS REQUIREMENTS LOCATION REQUIREMENTS VENTILATION REQUIREMENTS Electrical drill or ratchet driver 1/2” drill bit for drilling pilot holes 1¼” drill bit for drilling electrical wiring access hole Screwdrivers: Philips & Straight blade Pliers Tape measure or ruler and pencil Electrical supplies for wiring Aluminum foil tape and/or HVAC tape Hammer Jigsaw or saber saw Stud finder PARTS SUPPLIED Body & Main Unit: 1 pc. Mounting Bracket: 1 pc.
Recirculating Installations & Carbon Filters Non-Vented (Recirculating) Installations Carbon Filter Care Guide Ordering Carbon Filters If it is not possible to vent cooking fumes and vapors to the outside, the hood can be used in the non-vented (recirculating version, fitting a carbon filter at the motor. Fumes and vapors are then recycled through the top grille. Do not block the chimney holes and vents on either side.
Cleaning & Maintenance Cleaning Mesh or Baffle Filters Types of Metal Filters Interior Range Hood Cleaning Mesh and baffle filters can be cleaned with regular household dish washing soap and hot water. Please wear gloves while cleaning filters to protect against scrapes or cuts. Exercise caution around sharp metal edges and corners. Mesh The unit must be turned off before being cleaned. Also avoid spraying cleaner directly onto the light bulb or light bulb socket.
Installation Steps Prepare Location 3. Determine the required location for the home power supply cable and drill a ½" (1.3 cm) diameter hole for wire access. The range hood is to be installed 24" (61.0 cm) min. for electric cooking surfaces, 27" (68.6 cm) min. for gas cooking surfaces, to a suggested maxi- 4. For vented installations only: Using a jigsaw or keyhole saw, cut a 6½" (16.5 cm) diameter hole for the vent pipe / duct. mum of 36" (91.4 cm) above the cooking surface.
Installation Steps 6. Run the duct work between the hood and the outside. 9. Using 2 or more people, lift the range hood assembly and attach it to the angle irons. Install M5*10 screws on both side and tighten to secure. 7. Attach lower duct cover into upper duct cover (Lower duct cover should be bigger than 10. Pull the lower chimney cover down to complete installation. the upper duct cover).
Using Range Hood & Control Panel . A. Chimney Holes (For non-vented installation only) B. Chimney C. Control Panel D. Range Hood Body / Main Unit E. Metal Grease Filter F. Lamp Cover G. Grease Filter Release Handle / Latch Operating the Lights The light button controls both lights. Press once to turn on and again for off. Operating the Blower The fan speed buttons turn the blower on and control the speed. The speed can be changed anytime during fan operation by pressing the desired blower speed button.
RETURNS & WARRANTY RETURNS, DAMAGES, MISSING PARTS We thank you for your purchase. If you are not satisfied with your purchase or have an issue with our product, please kindly let us know. Our full returns policy is outlined below. Carefully read over our terms before contacting us. If you have questions, our customer service team can be reached at: +1 (626) 321-9834 or support@shoprangehoods.com.