Instruction Manual

Attaching Feet for Tabletop/Shelf Mounting

If you going to set your SuperCinema 3D Array Speaker on a table or bookshelf, install the included Adjustable

Center Stand Feet as follows:

Tools required: #2 Phillips Screwdriver

Small Flat Blade Screwdriver (for adjusting tilt back)

Parts included: Two Adjustable Feet with Rubber-Tipped Set Screws

Two Phillips head screws

Instructions:

1. Carefully lay the SuperCinema 3D Array on its face on a soft padded flat object, such as a table with

a towel or blanket, taking care not to damage the speaker or grille.

2. Align Foot with matching insert as shown below.

3. Insert the screw through the stand and into the inserts on the speaker’s back.

4. Tighten the screw into the insert in the back of the SuperCinema 3D Array, do not over tighten.

5. Repeat steps 2, 3 and 4 with the second Adjustable foot.

6. Adjust the height of the rubber-tipped set screws to achieve the desire angle. You can adjust the set

screw from above using the small flat blade screwdriver. Caution should be exercised to rotate the

speaker’s weight off the tip before adjusting to prevent damaging the rubber tip.