User Manual

Wing Assembly
1.Aileron push rod linkage set. 3x61mm Pushrods for aileron.
2.It is much easier to install the twin control horns before installing the wing. Locate the fiberglass aileron
control horns, ball links, and associated bolts and nylon-insert lock nuts. Use some fine sandpaper to
roughen up the center areas of the two control horns so that the glue adheres better. Using a sharp hobby
knife cut the covering away from the slots in the rudder and trial fit the two control horns.
3. Mix up some 30 minute epoxy and coat the inside of the slots and the center of the control horns. Hint:
a scrap piece of 1/16” ply, tooth pick, or old hobby blade can be used to coat the inside of the aileron slots.
Slide the control horns in place and make sure they are centered perfectly by using a ruler to measure
between the pivot holes and the hinge line. Wipe any excess glue off with isopropyl alcohol and paper
towels. Install the ball links, bolts and nuts into the holes to help assure alignment of both control horns
while the glue cures. Set aside until cured.