User Manual

5. Assemble the throttle servo mount using the supplied laser cut parts or there is a servo cutout in the
bottom of the engine box for 50cc-70cc engines. Mount your throttle servo and complete your linkage
setup. A hole will need to be drilled on the firewall to allow the pushrod to connect to the throttle arm on
the carb.
6. An extra servo can be fitted for choke or a mechanical linkage can be used.
7. The new KUZA 500cc Fuel Tank with aluminum tank cap is preassembled. Complete the installation in
the fuselage using zip ties or velcro straps to hold the tank in position. Connect a fuel line between the tank
and carb, a fuel line between the tank vent and the bottom of the fuselage, and a fill line to a fueling port
which can be mounted on the fuselage side opposite your ignition switch. Make sure your vent line does
not come close to any hot exhaust part such as the muffler or canister. recommends the use of small zip ties
or fuel line clamps to secure the lines to the tank.