User Manual

3．Installation of Elevators
Connect extension servo wire, secure with safe clips.
Attach elevators with 3X12mm Hex-head bolts and washers.
4.Install the wings onto the fuselage being careful to align the wing tube with the wings and not force it.
The wing tube may be initially tight but will loosen some with use. Guide your servo wires into the
fuselage openings and connect to the proper aileron channels. Servo clips are recommended. Once you
have the wings fully seated in the fuselage tighten the wing bolts inside the fuselage.
5. Fill your fuel tank making sure your vent line is not plugged or capped. With the canopy off, this is a
good time to check for any fuel leaks.
6. Position the canopy in place and tighten ALU Canopy Bolts. Be sure to use the supplied PTFE
washers under the screw heads.