User's Manual

FSM Cable Installation & MEU Activation
Page 39 of 43 Rev. 1A, Rev. Date: 8/31/2006
Use or Disclosure of this document is covered under the Non-Disclosure Agreement executed between the
prospective vendor and Goliath Solutions LLC.
4. Initial MEU startup in the following picture.
a) Note the firmware version code and phone number are present and correct (red
underline).
b) Note the MEU serial number is shown on-screen (thicker red underline). The
number starts directly after the ‘10’ and extends 8 characters.
c) When the MEU is turned on or RESET, you will have 10 seconds to press the ‘*’
key. This will cause the MEU to enter Command Mode. The timer will be increased
in later releases of Spider.
5. MEU Antenna Configuration
a) It is very important that the FSM perform an auto-configuration before performing
any manual configuration that may be necessary.
a. SHIFT + ‘Y’ = 3-Tx & 12-Rx auto-configuration
b. SHIFT + ‘T’ = 3-Tx & 13-Rx auto-configuration
b) Performing an auto-configuration reprograms the MEU with the appropriate sleep
time & phone number as well as facilitating less typing.
c) Manual configuration is done by pressing the ‘K’ key and typing the number of the
TX they wish to configure followed by the ENTER key. Then the FSM types the