User's Manual

FSM Cable Installation & MEU Activation
Page 42 of 43 Rev. 1A, Rev. Date: 8/31/2006
Use or Disclosure of this document is covered under the Non-Disclosure Agreement executed between the
prospective vendor and Goliath Solutions LLC.
equipment. Troubleshooting procedures should be implemented to narrow the problem
down.
h) If an antenna combination does not appear despite the equipment being present and
plugged-in, then an incorrect antenna configuration is the cause.
7. Dialing Out.
a) Once the “Dot Animation” sequence is complete, the MEU will attempt to dial out
and dump its data to the Modem Bank server via the telephone line.
b) If the MEU functions as it should, the user will see the modem initialize and after a
few seconds, see the line, “Connected at 38,400 baud!” This indicates a successful
connection to the Modem bank server.
c) The user will then see incomprehensible lines of code scroll upward on the screen.
This indicates the MEU is dumping its data to the server.
d) Once the data dump is complete, the user will see a summary line.
e) After a minute or so, the user should see, “140 minutes to go”, or something
similar. This indicates that the MEU is counting down to its next full-cycle.
f) If the display shows, “No Carrier” or “No Dial Tone” more than 3 times,
troubleshoots the phone line.
g) If the display shows, “Busy” more than 2 times, check the phone line for activity.