User's Manual

FSM Cable Installation & MEU Activation
Page 6 of 43 Rev. 1A, Rev. Date: 8/31/2006
Use or Disclosure of this document is covered under the Non-Disclosure Agreement executed between the
prospective vendor and Goliath Solutions LLC.
In Store Procedures:
Check-In:
Upon arrival at the store the following activities must take place:
1) If possible arrive at the store prior to the scheduled arrival time of the Cabling Vendor.
2) Review the pre-installation survey detail prior to the install.
3) Locate the store manager.
a) Introduce yourself to the store manager. If the Cable Vendor is on site make sure that
they were introduced to the manager. (Please note: A photo ID will be required.)
b) Explain the reason you are on-site, the approximate length of the installation and the
areas of the store where the installation team will be working.
4) When the Cabling Vendor arrives at site introduce yourself and update the cable vendor the
current status of the install and introduce them to the manager.
5) Locate the equipment shipped to the store and verify that you have the correct number of
boxes. Check the invoice for the MEU serial number (You may have to open the MEU box
to get the serial number). The equipment is normally shipped in three cartons. They are:
Cable – one carton containing the 110’ BNC ended plenum rated cables, 85’ BNC
ended plenum rated cables and 25’ BNC ended plenum rated cables.
MEU – One carton containing the MEU, Power Supply, 75’ or a 110’ power cable.
ATA/ARA Kit – One carton containing 12 ARA – Receivers and 3 ATA –
Transmitters. You may receive up to 14 receivers based upon store configuration.
6) Use your notebook PC with the Verizon Air Card and update the store record in QuickBase
with the following information:
a) MEU Serial Number.
b) Start Time (The time is entered in a 24 hour format).
If you do not have internet access or there are other issues that could prevent a
successful installation then call the Goliath help desk at 866-378-9956 and update them
on the situation.