User's Manual

Walgreens Installation Guide
G-1-2001-2B
Walgreens Installation Guide 2A.doc
Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions,
LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.
5/27/2008 Page: B-10
GOLIATH QA Checklist
QA Date: Corrections Start Time: Corrections End Time:
Store #: Store Name:
Address:
Manager: Store Phone:
GOLIATH Technician:
Tasks
Completed
Pictures
Taken
QA Tasks
All cables have been labeled with the appropriate number at both ends of the cable.
CMU installed according to defined standards.
The port where the patch cable for the CMU is plugged into on the network switch is clearly
labeled for GOLIATH Solutions.
The MEU is installed according to defined standards and easily accessible with ladder.
Power for the CMU and MEU is plugged into a dedicated, uninterrupted 24-hour power
supply.
All cables are correctly connected to the appropriate MEU port.
Cables run through the roof girders or properly suspended from roof girders.
Cables should not be touching ceiling tiles, light fixtures, power conduit, water lines, cables
that support ceiling grids, threaded support rods, and AC ductwork.
Excess cable in an accessible self supporting service loop above all antennae using cable
ties.
The ceiling grids labels identifying the Rx/ARA locations have been installed on ceiling grid.
The label should be pointing to the Rx/ARA and the back of the store.
All Tx/ATA and Rx/ARA antennae are installed at the correct locations.
All debris from the installation has been cleaned up (including in ceiling).
All ceiling tiles have been put back into place.
System test has been completed successfully.
Were OBF failures reported to the Help Desk and removed from the store?
Ask the Store Manager to rate the store installation experience 1 to 5. (1 is poor, 5 is
excellent) y issues and comments
If the store installation process is not a 5 document why?
Update QuickBase and SysMon and verity they are accurate.
Document any issues with the installation on the following page.