User's Manual

Walgreens Installation Guide
G-1-2001-2B
Walgreens Installation Guide 2A.doc
Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions,
LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.
5/27/2008 Page: B-16
Pre-Installation Survey Checklist:
During the Store Survey the CIT installation team will be provided a store floor plan with the suggested
locations for the Goliath equipment. The CIT team needs to verify that the store floor plan is correct and
then determine the location to install the Goliath Equipment.
If the store floor plan is not correct; go to
the Floor Plan Questions section found in the “
Walgreens Store Floor Plan Reference Guide”.
Gather the information asked in these questions and then contact the Help Desk. The Help Desk
will then help determine the actual floor plan.
The suggested locations for the Goliath equipment must be validated during the store survey. Conditions
found in the store during the survey will determine the actual location of the Goliath equipment. During the
check-in call with the Goliath Help Desk notify them of any changes to the equipment location from the floor
plan and any exception issues. Some of the factors that affect the actual location of the equipment are
access to the suggested location, A/C ductwork and vents, security screens and cameras, emergency
lighting, water pipes, sprinkler heads and mirrors.
Once the location of the equipment has been determined, use painters tape to mark the designated
Rx/ARA or Tx/ATA number on the sales floor below the desired location. Only use painters tape on the
floor in the stock room. The mark or the tape must be removed prior to the completion of the installation.
The following table highlights exceptions or issues that must be verified during the store survey. The table
is divided by the area of the store and the piece of Goliath Equipment. Refer to chapter 2 and appendix A
– Antenna Placement in the Walgreens Installation Guide (G-1-2002) for detailed installation and survey
instructions.
Remember the power source for the CMU and MEU must be a dedicated 24 hour
uninterrupted power outlet. Power strips and power cubes can not be used.
Only enter Pharmacy if there is not Catalina Cabinet. Follow policies
defined in Walgreens Environment for access.
Area/Equipment Issues
CMU
 Check in the Photo Department for the secondary communications
(Catalina) cabinet. It may be located in the yellow storage closet. If
the cabinet is not located in Photo ask the Store Manager for its
location. If the store does not have a Catalina cabinet, then use the
Communications cabinet in Pharmacy. Review Walgreens
Environment on policies for entrance into Pharmacy.
 Validate the following information inside the cabinet:
o An available dedicated available 24-hour uninterrupted power
outlet.
o An open network port on the switch.
 Validate an available location to mount the CMU on the wall near the
communications cabinet.