User's Manual

Walgreens Installation Guide
G-1-2001-2B
Walgreens Installation Guide 2A.doc
Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions,
LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.
5/27/2008 Page: B-18
Cable Pulls
 Determine the path of your cable pulls to the front, middle and back of
the store from the MEU location.
 Determine how the cables will enter the stock room and what pull they
will be with.
 Determine any issues in the ceiling that would affect your cable pulls.
They would include but are not limited to:
o Obstructions in the ceiling (HVAC, ductwork, water pipes, conduit).
o No roof girders.
o Roof girders that is too high above the drop ceiling for access from
the ladders.
 Determine the length of the cables required to go from the MEU to the
designated location of each antennae.
Tx/ATA and
Rx/ARA
Antenna
Placement over
the Sales Floor
Validate that the designated location meets the following requirements:
 Clean line of site to the floor. It can not be located over shelves,
signs or display tables.
 A Tx/ATA must be installed on a full tile.
 An Rx/ARA should be installed on a full tile, but can be installed on a
partial tile if needed. The partial must be either square or rectangle
and can not have any custom cuts.
 Nothing else is installed on the tile such as:
o A/C intake or outtake vents.
o Sprinkler heads.
o Security cameras or screens.
o Emergency lighting.
o Speakers
o Any other equipment.
 There is access in the ceiling to install the antenna.
 All antennae must be a minimum of 10 feet from each other.
 If the location for Rx-5 and Rx-9 must be adjusted, skew it
towards aisle 1.
 If the location for Rx-8 and Rx-12 must be adjusted, skew it
towards the last aisle normally that is aisle 9 or 10.
If the designated location does not meet these requirements locate the
antenna to the closest tile that meets these requirements. Normally this
would only be one tile over. If it is more than one tile notify the Goliath Help
Desk. If any antenna appears to be in the incorrect location on the floor
plan validate that location with the Goliath Help Desk.