User's Manual

Walgreens Installation Guide
G-1-2001-2B
Walgreens Installation Guide 2A.doc
Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions,
LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.
5/27/2008 Page: B-20
Stock Room
Access
 Determine it there is an existing access point to the stock room from
the store. This access point can not be shared with water pipes.
electric conduit or A/C ductwork.
 If there is not an existing access point, then determine if one can be
cut. Use the appropriate tools (drywall saw or hole saw) to cut the
hole. If it is a firewall, firewall conduit is required to be installed
according to the manufactures’ specifications.
 If there is no access is available to the stock room a second MEU will
be required. Contact the Goliath Help Desk.
Tx/ATA (24)
Validate that the designated location meets the following requirements:
 Clean line of site to the floor. It can not be over pipes, shelves or
merchandise stacked on the floor.
 The Tx/ATA must be attached to a roof girder using cable ties.
 The Tx/ATA can not touch conduit or pipes.
 Tx/ATA (24) should be located about half way between Rx15 and
Rx16 next to the loading belt.
 The Tx/ATA should be centered as best as possible on the aisle
between the loading belt and the shelves and over the natural
walking path.
 The Tx/ATA should be a minimum of 10 feet from each Rx/ARA.
Rx/ARA (15, 16)
Validate that the designated location meets the following requirements:
 Clean line of site to the floor. It can’t be over pipes, shelves or
merchandise stacked on the floor.
 The Rx/ARA can be attached to a roof girder using cable ties or
suspended from the roof girder using plastic plumber’s strap.
Preferably cable tied.
 The Rx/ARA can not touch conduit or pipes.
 Rx (16) should be located near the start of the loading belt near the
receiving door.
 Rx (15) should be located at the opposite end of the receiving belt
furthest from the receiving door.
 The Rx/ARA antenna should be centered as best as possible on the
aisle between the loading belt and the shelves and over the natural
walking path.