User Manual Part 1

Introduction to Store Install Processes Guide
G-1-2001-2
Introduction to Store Install Process Guide-2.doc
Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions,
LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.
5/27/2008 Page 3-6
CMU/MEU Power Supply:
The power supply will be plugged into an uninterrupted
power source and provide power for the CMU or MEU.
CMU/MEU Power Cables:
Three different power cables can be used with the CMU
and MEU. The are:
1) A 110 foot low voltage power cable. This cable
is used to extend the distance from the MEU or
the CMU to the power source. The female end
of the cable will always be at the power supply.
If used with the MEU the male end must be at
the MEU.
2) A 12 foot low voltage power cable. This cable is
normally used at the CMU location if needed.
3) A Gender Changer cable. This cable is used to
connect the female end of a power cable to the
output power port on the CMU. This port has a
female connector.