User Manual Part 1

Introduction to Store Install Processes Guide
G-1-2001-2
Introduction to Store Install Process Guide-2.doc
Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions,
LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.
5/27/2008 Page 4-4
Tx/ATA Installation:
 The antenna locations will be verified during the Pre-installation Survey performed by
the Lead Technician.
 The location of the Tx/ATA should be placed directly over the flooring with a clean line
of sight to the floor, not over any fixtures or tables.
 A minimum of 4 transmitters will be installed in the store.
 The transmitter will be installed in a ceiling tile or attached to a roof girder iron or
attached directly to the roof.
 The Tx/ATA must always be plumb – this may require shimming the antenna base
above the ceiling.
Tx installed in ceiling tile
Tx I
nstalled
on a
roof girder