User's Manual

Walgreens Installation Guide
G-1-2002-2B
Walgreens Installation Guide 2B.doc
Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions,
LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.
5/27/2008 Page: 2-39
Other important requirements are, but are not limited to:
 Do not bend cables at a sharp 90 degree angle since this will damage the cables.
 Care must be taken not to over tighten the cable ties so the internal cable does not
break.
Cable Pull Procedure:
1) All cables must be labeled approximately 6 inches from each end of the cable. This
label will designate the port on the MEU and the antenna in which the cable is to be
connected. The Tx/ATA and Rx/ARA locations can be marked on the floor as per the
Pre-Installation Store survey.
2) If you extend a cable, move the label from the end of the original cable to the end of
the extended cable.
3) Uncoil/unroll previously labeled coaxial cables down the aisle and then around the end
cap into the next aisle. Only uncoil the cables required for your current cable pull.
 If you are pulling the cable run that includes the power cable you need to
remember that the power cable has a male and female end. You must pull the
power cable in the correct direction. The male end of the power cable will go the
MEU and the Female end will go to either the power supply or the power output
port on the CMU.
“Incorrect Method
-
Cables
strewn
in an aisle
“
This is a hazard for customers and employees.
The cable will kink and may be damaged when you pull it.