User's Manual

Walgreens Installation Guide
G-1-2002-2B
Walgreens Installation Guide 2B.doc
Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions,
LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.
5/27/2008 Page: 2-51
Installation of the Tx/ATA antenna in the Stock Room:
1) Verify that the cable will reach the designated antenna location.
2) Mount the Tx/ATA to the roof girder at the designated location using cable ties.
 The Tx/ATA must always be plumb.
 The Tx/ATA and cable cannot touch any power conduit or any other pipes.
 The Tx/ATA must have a clear line-of-sight from the center of the antenna directly
to the floor. The Tx/ATA can not be mounted directly above pipes or conduit that
obstructs the line of sight to the floor.
3) Create the service loop per the previously stated standard and then connect the
coaxial cable to the antenna.
 The excess cable at the antenna point of termination must be looped (coil should
be no less than ten (10) inches in diameter) and secured to itself using cable ties.
Be very careful not to kink or bend the cables
 The loop must then be placed on top of the roof girder, directly above the antenna
and secured to the girder via a cable tie.
 Be careful not to tighten the cable tie to the point where the cable is pinched.
Correct Tx/ATA Installation in Stock Room:
1