User's Manual

Walgreens Installation Guide
G-1-2002-2B
Walgreens Installation Guide 2B.doc
Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions,
LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.
5/27/2008 Page: 2-27
Installation Prep:
1) Unpack the Installation Kit and review its contents.
2) Sort the installation kit into the following categories:
 Rx/ARA Antennas
 Tx/ATA Antennas
 CMU
 MEU
 Power Supplies and power cables
 25 foot cables
 50 foot cables
 85 foot cables
 110 foot cables
3) Place a corresponding grid label on the side of each Rx/ARA that will be installed in
the store. The grid label will be installed on the ceiling grid when the antenna is
installed. You can also attach the Xmas tree fastener so all the items needed to install
the Rx/ARA is in one location.
4) Verify you have received the equipment listed on the packing slip and none of the
equipment is damaged.
5) Notify the Help Desk of any damaged or missing equipment during the check-in call.
6) After the completion of the Pre-installation survey begin labeling the cables with the
labels provided for installation. The length of the cables should have been determined
during the Pre-installation Store Survey.
 All coaxial cables must be labeled at both ends.
 Labels should be 6 inches from the cable end.
Grid Labels