User's Manual

Walgreens Installation Guide
G-1-2002-2B
Walgreens Installation Guide 2B.doc
Use or disclosure of this document is covered under the Non-Disclosure Agreement executed between the reader and Goliath Solutions,
LLC. This document and the information contained herein are privileged and should only be viewed by expressly authorized parties.
5/27/2008 Page: 2-28
7) As the cables are being labeled place all the cables and the associated Rx/ARA and
Tx/ATA antennas for a cable pull in one pile. For example a 10 aisle store with a back
stock room may require four cable pulls. The equipment would be sorted into 4 groups
that correspond to the cable pulls for the store. The groups would be:
Front Pull: Power cable, Cables 1, 3, 4, 13 and 21, 1 Tx/ATA and 4 Rx/ARA
antennas with grid labels GolSol 1, GolSol 3, GolSol 4 and GolSol 13
Back Pull: Cables 9, 10, 11, 12, 23, 15, 16, 34, 2 Tx/ATA and 6 Rx/ARA antennas
with grid labels GolSol 9, GolSol 10, GolSol 11, GolSol 12, GolSol 15
and GolSol 16
Middle Pull 1: Cables 2, 5, 6, 22, 1 Tx/ATA and 3 Rx/ARA antennas with grid labels
GolSol 2, GolSol 5 and GolSol 6
Middle Pull2: Cables 7, 8, and 2 Rx/ARA antennas with grid labels GolSol 7 and
GolSol 8
8) With the equipment prepped and sorted based on the cable pulls, then CIT can take
the equipment required for the cable pull they are working on and position that
equipment in the appropriate location for installation They will also need to take Xmas
tree fasteners (for the Rx/ARA) and rubber collars/gaskets (for the Tx/ATA).
Correct Label position
.
In
-
correct Label
Position
Cable lengths are
marked on the cable
02C85 = 85’ cable
002C-25 = 25’ cable
Cable labels