Operation Manual

The door panel has two memory banks
to plug 256Kb memory modules in.
Each module allows to record the custom
text for a maximum of 968 users.
The system is delivered with one memory module
placed in the bank number 0 (BK0), where
the system configuration will be recorded.
IMPORTANT: in case of door panels with two memory modules,
don't change their bank position once they have been recorded.
BK0 bank module must always have a memory module plugged in.
IMPORTANT:
IMPORTANT:
BK0
BK1
112
DOOR PANEL INSTALLATION
ptional. EL560 module for video installations
with twisted pair cable.
O
Plug the EL560 module in the CN6 connector.
The CN4 connector is accessible by unbolting
the four screws of the pcb protection cover.
NOTE: on this type of installations the EL562 module
must be plugged in all the monitors.
Refer to the specific installation diagram.
emory banks.
M
omputer connection.
C
It's possible to program the door panel using a
computer through its RS-232C port.
An interface (not included) should be connected
to CN8 door panel connector. MEMEDIT software
(included with the interface) will allow to program
the door panel and to save a copy of each system.
In case of memory damage it will be possible
to restore the system configuration from the computer.
nformative module lamps wiring.
I
113
DOOR PANEL INSTALLATION
inal
adjustments.
F
If after starting the system it's considered that the audio
volume isn't correct, proceed with the necessary
adjustments as shown.
The telecamera has a pan and tilt mechanism built in
to adjust the telecamera position.
In case of low light conditions, an external illumination
can be activated by connecting a R-3 relay
between terminals '+H' and 'L2' of the sound module.
IMPORTANT: The power to the R3 relay must not
exceed 12 Vca and 1,6A.
lose the door
panel.
C
Fix the door panel by using the supplied
screws.
Finish the door panel assembly by pressing
the closing heads.
Once the informative labels are placed, wire the
lamps from different modules and connect them
to terminals L1 and L2 of the sound module.