Operation Manual

MONITORS PROGRAMMING
132
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, both monitors or telephones.
Make a call to make sure that the monitor has been properly programmed.
Repeat these steps to program the rest of monitors.
Once the programming has been finished exit from the programming
menu by pressing key. If you don't, the door panel will automatically
exit after 90 seconds with no operation.
For Platea Uno monitors:
O.K.
01
O.K.
01
For both monitors:
rogramming the monitors.
P
Turn off the monitor to be set, by pressing the door opener
button during 1 second.
Once it has been turned off, press the autoswitch-on button.
Keep the autoswitch-on button pressed and without releasing it,
press the door opener button.
The doorpanel will produce tones to indicate that the
device is ready to be set up.
The monitor will show the image and it will be possible
to release the other buttons.
Lift the handset from the monitor.
To set up the monitor as the master one, put
down the handset.
To set up the monitor as a slave one,
press the door opener button and then put
down the handset.
Enter the code of the monitor to be
programmed and press the key.
At this moment the panel will reproduce
a sound and the monitor led will blink.
CONDAL TELEPHONE DESCRIPTION
escription of the T-940 Plus / T-940 Uno telephones.
D
a.
b.
c.
d.
e.
f.
g.
h.
i.
Telephone handset.
Speaker grille.
Microphone hole.
Subjection hole.
Telephone cord connectors.
Function push buttons.
On-Off light indicator.
Call reception volume control.
Hook switch.
a
d
c
e
i
h
e
b
f
g
The T-940 Plus telephone has a three positions switch placed on
the bottom part of the telephone (closest to the telephone cord
connector) that allows to control the call reception level
volume.
unction push buttons.
F
On-Off push button.
After any telephone reset, and during the next 45 seconds,
all the telephone functions will be disabled, with the exception
of call reception (Only T-940 Plus).
This push button allows to make an intercom call when the handset
is not on the craddle. This function is described on page 151
(Only T-940 Plus).
If the handset is on the craddle sends a panic call to the porter's
exchanges that have enabled the reception of this type of call
(Only T-940 Plus).
If not, allows to call to the master porter's exchange.
During call reception and communication progresses allows
the lock release activation.
a.
b.
c.
a
b
c
133
Push button on
T-940 Uno