Instructions

17
4 Installing and Operating
4.1 Preparing
1. Check the scope of delivery for completeness and integrity.
 &RPSDUHWKHSHFL¿FDWLRQVRISURGXFWSRZHUVXSSO\DQGSHULSKHUDOV
They must be identical.
4.2 Mounting
Risk of injury by stumbling and falling
Place, install and transport product, product ts and accessories
in a safe way.
1. Insert the base (3) with the motor block
and the fan speed adjustment push
buttons into the base (1), Fig 13 a).
2. Turn the whole thing over so that the
underside of the sockets and the
base can be seen, Fig. 2 b).
3. Tighten the base with the Phillips
screws (2). Tighten the Phillips screws
Fig. 13: Mounting base clockwise.
4. Slide the rear guard grille (4) onto the
axle (12) and the centering pins (13) of
the engine block. See Fig. 14 a).
5. Slide the hexagon nut (5) onto the axle
in front of the rear guard grille and
tighten clockwise. See Fig. 14 b).
Fig. 14: Mounting of rear guard grille
6. Push the rotor (8) onto the motor axle (12).
The small transverse axis (14) at the end
of the motor axis must lie in the recess of
the rotor attachment. See Fig. 15 a).
7. Place the nut (9) on the rotor.
8. Tighten the nut clockwise.
See Fig. 15 b).
Fig. 15: Monting rotor