User manual

4. Connect the red battery cable (10) with the eyelet to the positive terminal

of the battery.

This is red or marked with „P“ or „+“.

5. Connect the black battery cable (10) with the eyelet to the negative pole

of the battery.

This is black or marked with „N“ or „-“.

Voltage converters, which are supplied with 2 red and black battery cables

each, ALL cables must be connected with loads >1000 W.

Risk of electric shock!

• Not connecting the ground terminal may cause electric

shock when equipment defects.

6. Connect the ground cable (11) to the ground terminal (4) and to an

available ground system such as the vehicle body or for stationary use,

at equipotential.

5 Operation

5.1 In general

Some external devices such as audio and battery-powered devices and pre-

cision equipment may not be suitable to operate at a voltage converter and

the connected device and/or the voltage converter may get damaged.

1. Check the user manual of the device to be connected to corresponding

notices.

2. Turn the device off immediately and unplug the power cord when it hums

or excessively heates up.

3. If there is anything unclear, contact the dealer of your device.

Both AC outputs 230 V (7) and the DC output USB 5 V (9) can be used si-

multaneously. The total power rating for all connected equipment must not

exceed the continuous output of the voltage converter. The power rating of

your equipment can be found on the nameplate. External devices, such as

electric motors, drills, electric saws, refrigerators and music systems normally

have a higher rated power when starting as indicated on the nameplate. The

voltageconvertercanthereforebrieymakeahigherpeakoutputpowerifthe

power rating is only given in current as ampere,

• multiply the value in amperes (A) by a factor of 230 to to obtain the power

in watts (W).

Example: 0.5 A x 230 V = 115 W

The vehicle battery discharges when the vehicle is not in operation.

5.2 Switching the voltage converter on/off

1. TurntheOn/Offswitch(8)on(ON).

If the Operation LED (5) lights, the voltage converter is ready for operation.

2. Should the Error LED (6) light, turn off the voltage converter by pressing

 theOn/Offswitch(OFF)andreadthechapter„Troubleshooting.“