User manual

17
User manual
4 Preparation
• Comparethespecic ationsofalluseddevicestoensurecompatibilit y.
• Checkthescopeofdeliveryforcompletenessandintegrity.
5 Installation
Risk of electric shock
• Let open cable ends ONLY assemble by experienced
electrician.
• Cutoffpowersupplybeforeanyworkontheproduct,
switch off safety fuse and secure against reconnection.
• Assure and check the absence of voltage before any
work on the product.
The power cord used should have a minimum cross section of 1.0 mm². The
following connections are made to the terminal block of the product.
1. Connectyourlamps(LOAD)likeshown.
If using several lamps, they must be wired in parallel.
Power cables are installable sidewise or from above.
2. Fix all wire connections using a screwdriver.
3. Insulate the connection against contact and moisture.
The earth wire will not be connected.
5.1 Installation without separate light switch
Fi g . 7: Installation without separate light switch