User Manual
Table Of Contents
- Table of Contents
- Safety Instructions
- Copyright
- Trademarks
- Introduction
- Features
- Package contents
- System requirement
- Product overview
- Connection
- DIN mounting kit installation
- Pin assignment
- Using SEC (Serial-to-Ethernet Connector)
- Quick starting guide
- Serial to Ethernet Toolkit
- Web console
- Telnet console
- Regulatory compliance
- Specification
24
11. Create UDP connection at the remote end. Repeat steps
1-10 listed above. Make sure that the port numbers are
the same at both ends and are not blocked by îš¿rewall.
12. Now you are ready to start communication process with
default settings. You can refer to Editing UDP connection
section if you would like to edit a newly established
connection.